######################################################################## # EEPROM settings text file # # Edit this file for your particular board and run through eepmake tool, # then use eepflash tool to write to attached HAT ID EEPROM # # Tools available: # eepmake Parses EEPROM text file and creates binary .eep file # eepdump Dumps a binary .eep file as human readable text (for debug) # eepflash Write or read .eep binary image to/from HAT EEPROM # ######################################################################## ######################################################################## # Vendor info # 128 bit UUID. If left at zero eepmake tool will auto-generate # RFC 4122 compliant UUID product_uuid 00000000-0000-0000-0000-000000000000 # 16 bit product id product_id 0x0001 # 16 bit product version product_ver 0x0002 # ASCII vendor string (max 255 characters) vendor "Alberta Digital Radio Communications Society" # ASCII product string (max 255 characters) product "IP400 E04 HAT Rev A" ######################################################################## # GPIO bank settings, set to nonzero to change from the default. # NOTE these setting can only be set per BANK, uncommenting any of # these will force the bank to use the custom setting. # drive strength, 0=default, 1-8=2,4,6,8,10,12,14,16mA, 9-15=reserved gpio_drive 0 # 0=default, 1=slew rate limiting, 2=no slew limiting, 3=reserved gpio_slew 0 # 0=default, 1=hysteresis disabled, 2=hysteresis enabled, 3=reserved gpio_hysteresis 0 # If board back-powers Pi via 5V GPIO header pins: # 0 = board does not back-power # 1 = board back-powers and can supply the Pi with a minimum of 1.3A # 2 = board back-powers and can supply the Pi with a minimum of 2A # 3 = reserved # If back_power=2 then USB high current mode will be automatically # enabled on the Pi back_power 1 ######################################################################## # GPIO pins, uncomment for GPIOs used on board # Options for FUNCTION: INPUT, OUTPUT, ALT0-ALT5 # Options for PULL: DEFAULT, UP, DOWN, NONE # GPIO FUNCTION PULL # ---- -------- ---- setgpio 10 OUTPUT NONE # BOOT_ENA setgpio 11 OUTPUT NONE # RESET setgpio 14 ALT0 DEFAULT # TXD0 setgpio 15 ALT0 DEFAULT # RXD0